Results for "low pressure"

Filters Medium 1-3 hours 468 👍 0

Can Pool Filter Pressure Be Too Low? Diagnosis & Solutions

Found out from my wife that our pool filter pressure gauge has been stuck at a weirdly low 6-7 PSI all week and now I can't stop obsessing over it. My 20,000 gallon inground pool has been running fine otherwise, but I'm wondering if this low pressure is something I should be concerned about.

I've heard people talk about high filter pressure being bad, but nobody ever mentions if pressure can be too low. The pump seems to be running, but I'm not sure if the water flow looks as strong as it used to be. Water chemistry has been balanced - chlorine at 2.5 ppm, pH at 7.4, and alkalinity at 110 ppm. Should I be worried about this low pressure reading, and what could be causing it?…more

Read answer

Filters Easy 5 minutes 328 👍 0

How Long to Backwash Pool Sand Filter: Complete Guide

Since it's 11 PM and my sand filter pressure just spiked to dangerous levels — need to backwash this thing before my pump burns out overnight. Right now I'm dealing with my sand filter - the pressure has gone up quite a bit from when I first cleaned it, and I know it's time to backwash.

But here's my question: how long should I actually run the backwash cycle? I don't want to waste a ton of water (my utility bills are already high enough), but I also want to make sure I'm doing it properly. Is there a specific time I should aim for, or some other way to tell when it's done? I'd rather figure this out myself than pay someone else to do basic maintenance.…more

Read answer

Equipment Medium 45 minutes 257 👍 0

How Pool Vacuums Work: Complete Troubleshooting Guide

Since I'm planning to troubleshoot my pool vacuum this Saturday — should I expect suction-side, pressure-side, and robotic models to need completely different repair approaches? My current setup isn't performing optimally, and I want to diagnose whether the issue stems from suction pressure, mechanical components, or operational methodology.

What are the fundamental working principles behind suction-side, pressure-side, and robotic pool vacuums? I'm particularly interested in the engineering differences between each type and their common failure points. Understanding the mechanics will help me identify whether poor performance is due to inadequate water flow, clogged components, or system-specific malfunctions that require targeted solutions.…more

Read answer

Editor's Pick

Dolphin Nautilus CC Plus Robotic Pool Vacuum (2026)

Wall-climbing scrubber brush and Wi-Fi control — ideal for in-ground pools up to 40 ft. View on Amazon →

Sponsored

Filters Easy 30 minutes 287 👍 1

How to Use a Pool Sand Filter: Complete Step-by-Step Guide

The pool sand filter that worked fine for years started giving me cloudy water last month but now it's completely dead and those expensive pool store fixes aren't working.

Can someone just give me the straight facts on how to actually operate my sand filter? I want to know the basic daily routine, when I should backwash, and how to tell if it's working properly. I'm looking for simple, practical steps I can handle myself without breaking the bank on unnecessary add-ons.…more

Read answer

Water Chemistry Medium 45 minutes 249 👍 0

Can Pool Chlorine Make You Sick? Health Effects Explained

Opened my pool this season after adjusting pH levels, switching chlorine brands, and getting professional water testing — but my family still gets red eyes and skin irritation after swimming. We've been experiencing eye irritation and some skin redness after swimming, but I'm also worried about not having enough chlorine to kill bacteria and other nasties.

My latest test results show chlorine at around 5-6 ppm, and my CYA is sitting at about 50 ppm. I've been using liquid chlorine and shocking weekly with calcium hypochlorite. Sometimes the chlorine drops really low between treatments, maybe down to 0.5-1 ppm, especially after heavy use or rain.

What's the sweet spot for chlorine levels to avoid both chemical irritation and harmful bacteria? I want to keep everyone healthy but not sure if I should be targeting higher or lower numbers based on my current CYA level.…more

Read answer

Filters Medium 2-3 hours 1,299 👍 8

Pool Filter Balls vs Sand: Complete Replacement Guide

Noticed my pool filter isn't performing like it used to — can't afford professional service right now, so is switching from sand to filter balls a DIY job under $100? The pool store mentioned they might work better than traditional sand, but I want to make sure before I make the switch.

Are filter balls actually a good replacement for sand in my filter system? I'm curious about things like how well they filter compared to sand, if they're easier to work with, and whether the maintenance routine changes at all. Any guidance would be really helpful!…more

Read answer

Maintenance Medium Planning phase - 1 hour assessment 603 👍 1

How Long Can a Pool Be Empty? Safe Duration & Risks

Replaced my old above-ground pool with this inground concrete setup that needs major repairs, but I've never dealt with draining one before and I'm worried about structural damage. The pool will be without water for potentially several weeks while contractors complete the work.

What are the specific time limits before hydrostatic pressure becomes a concern? Are there differences in safe empty duration between inground concrete pools versus above ground pools with vinyl liners? I want to avoid any structural damage or liner issues during this extended maintenance period.…more

Read answer

Leaks Medium 2-4 hours 259 👍 0

How to Find Pool Leak: Complete Detection Guide 2026

Got my pool water level dropping a massive 2-3 inches this week and there's definitely something wrong beyond normal evaporation. My water chemistry is balanced (chlorine at 2.5 ppm, pH 7.4, alkalinity 120 ppm), so I don't think it's a chemical issue causing excessive evaporation.

I suspect there might be a leak somewhere but I'm not sure how to pinpoint the exact location. Should I be checking around the skimmers and return jets first? I've heard about using food coloring to detect leaks but I'm not sure of the proper technique. Also wondering if there's a way to test whether it's a structural leak versus something in the plumbing lines.

What's the most systematic approach to track down where exactly the water is going? I'd rather diagnose this myself before calling in a expensive leak detection service if possible.…more

Read answer

Pump Problems Easy 15 minutes 257 👍 0

How to Tell if Your Pool Pump Isn't Working Properly

This 4-year-old pool pump is turning my once-crystal-clear water cloudy and stagnant — is it worth repairing or should I just replace the whole thing? I'm not super technical when it comes to pool equipment, so I'm not sure what warning signs I should be watching for.

What are the telltale signs that indicate my pump isn't doing its job properly? I want to catch any problems before they turn into expensive repairs or leave me with a swamp instead of a swimming pool!…more

Read answer

Filters Easy 2–3 hours (including soak time) 11 👍 1

How to Deep Clean a Pool Cartridge Filter

Nobody tells you how fast sunscreen and body oils can clog up a cartridge filter. My pressure gauge has been creeping up steadily, and when I finally pulled the cartridges out, the pleats looked genuinely gunky — not just dusty, but greasy and discolored even after I sprayed them down with the garden hose. A neighbor suggested soaking them in Simple Green since it's a degreaser, but I'm nervous about it foaming up my pool water if I don't rinse it out completely.

My current routine is basically just a garden hose spray-down every few weeks, but clearly that's not cutting through the oils and sunscreen buildup. I want to know the full proper process — the right way to hose them down, whether Simple Green or a dedicated pool filter cleaner is the smarter choice, how to handle mineral scale versus greasy residue differently, and how often a real deep clean should actually happen.

Also, someone in my neighborhood group mentioned using a pressure washer to blast the pleats clean, and now I'm second-guessing everything. What should I absolutely avoid doing, and what's the correct method from start to finish?…more

Read answer

Maintenance Easy 5 minutes 303 👍 0

Pool Glossary: SLAM, Sanitizer, PSI, CYA & Common Pool Terms

I keep seeing pool terms and abbreviations like SLAM, CYA, FC, PSI, sanitizer, backwash, and shock. What do they mean in plain English?…more

Read answer

Product Ranking 8 compared

Best Pool Covers

4.5 (11,300 reviews)

Filters Medium 45 minutes 213 👍 0

Do I Need a Sand Filter for My Pool? Complete Guide

Since my pool water keeps turning cloudy even after cleaning, is it dangerous for my kids who swim almost daily? My pool has been a constant headache and I'm wondering if switching to a sand filter would solve my problems, or if there are better options out there.

I keep hearing different things - some people swear by sand filters because they're supposedly low-maintenance, others say cartridge or DE filters work better. My pool isn't huge but gets decent use, and honestly I just want something that actually works without me having to mess with it constantly. What's the real deal with these different filter types and how do I know which one would work best for my situation?…more

Read answer

Above Ground Medium 45 minutes 407 👍 0

Can Pool Liners Stretch? Above Ground Vinyl Liner Guide

Turned on my pool pump after winter and now my above ground liner looks completely different than it did last summer. There are these weird wrinkles that weren't there before, and some spots look thinner than others. My neighbor insists pool liners don't stretch, but something is definitely happening here.

The pool gets full sun most of the day and it's been brutally hot this year. I'm wondering if the heat and water pressure are actually causing the vinyl to stretch out? I'm trying to figure out if this is normal wear and tear or if I need to start budgeting for a new liner. Has anyone else noticed their liner changing over time?…more

Read answer

Equipment Easy 15 minutes 352 👍 0

How Long Do Pool Cleaners Last? Lifespan by Type

Called three pool stores and they're all closed — my robotic cleaner just died at 11 PM mid-cycle and I need to know how long these things should last before buying another overpriced replacement tomorrow.

I want to make a smart investment and buy something that'll actually last, but I need real numbers. What's the typical lifespan I can expect from robotic cleaners versus pressure cleaners versus suction cleaners? I'm willing to do proper maintenance myself to extend the life - just tired of throwing money away on equipment that craps out after a year.…more

Read answer

Algae Green Pool Medium 2-4 hours 252 👍 1

Does Cloudy Pool Water Mean Algae? Diagnosis Guide

Walked out to my 20,000 gallon inground pool this morning and the crystal clear water from three days ago is now completely cloudy. They've been asking to use the pool, but I'm worried this cloudiness might mean we have an algae problem that could make them sick.

I'm not sure what's causing the cloudiness - could it be algae starting to grow, or might there be other reasons? How can I tell the difference between algae and other issues that cause cloudy water? I want to make sure I properly diagnose what's wrong before letting the kids back in the pool.…more

Read answer

Loading more Q&A...

You've seen all 77 Q&A articles!