The SLAM method (Shock Level And Maintain) clears green pools by maintaining high chlorine levels continuously until water clears. Use liquid chlorine to reach shock level based on CYA, maintain 24/7 until overnight chlorine loss is 1ppm or less.
Pool opening involves removing winter covers, inspecting equipment, reconnecting plumbing, and balancing water chemistry. Start with equipment inspection, fill and reconnect systems, then shock and balance chemicals before swimming.
Pool winterization involves balancing chemicals, protecting equipment, and proper closing procedures. The process varies by climate zone but typically includes shocking, lowering water levels, and winterizing plumbing to prevent freeze damage.
You can vacuum your pool after adding most chemicals, but timing matters. Wait 15-30 minutes for liquid chemicals to circulate, and 2-4 hours for granular chemicals to fully dissolve before vacuuming.
Pool algae can cause skin rashes, irritation, and other health issues through direct contact or by creating conditions that harbor harmful bacteria. The key is eliminating algae through proper SLAM treatment and maintaining balanced water chemistry.
Salt water pools are not self-cleaning and require regular maintenance including proper water chemistry balance, algae prevention, and equipment upkeep. The salt water generator only produces chlorine automatically but doesn't eliminate the need for active pool care.
Yes, pools can leak through tile grout when it becomes cracked, deteriorated, or improperly sealed. Grout leaks typically occur at the waterline where freeze-thaw cycles and chemical exposure weaken the grout over time.
Yes, pool leaks can potentially cause sinkholes by washing away soil around your pool's foundation. While rare, continuous water leakage can erode the soil structure, creating voids that may eventually collapse into sinkholes.
Pool jets can indeed leak from loose fittings, cracked housings, or plumbing connections behind the wall. Most jet leaks occur at the fitting where the jet screws into the return line or from deteriorated gaskets and O-rings.
Yes, you absolutely need to wash pool filter sand before installation. New sand contains dust, debris, and fine particles that will cloud your pool water if not properly cleaned first.
Cartridge pool filters cannot be backwashed like sand or DE filters. Instead, they must be removed and cleaned by hosing off debris, soaking in cleaning solution, and rotating between multiple cartridges for best results.
Pool chlorine does not make your skin darker. The sun exposure you get while swimming in the pool causes tanning, not the chlorine itself. Chlorine can actually make skin more sensitive to UV rays.
Winterizing your pool involves balancing water chemistry, lowering water levels, removing equipment, and adding winterizing chemicals. The process takes 4-6 hours and prevents freeze damage while maintaining water quality through winter months.
Wait 8-24 hours after shocking before vacuuming your pool, depending on chlorine levels and shock type. Test free chlorine first - it should drop below 5ppm for safe vacuuming.
Yes, above ground pools can be converted to salt water, but you need to verify liner compatibility, install a properly sized salt water generator, and maintain CYA levels between 70-80 ppm for optimal performance.
