Results for "pvc leak"

During the estimate call, my pool guy quoted me close to $200 to cut out and re-plumb a leaking glued PVC joint right at my pump — and honestly that feels steep for what looks like a tiny weeping drip. I picked up a stick of J-B Weld WaterWeld (the 8277 epoxy putty) at Home Depot for about nine bucks, and I'm wondering if I can just knead it up and pack it around that joint myself instead of paying someone else to do it.

My main questions are: will this stuff actually hold against the water pressure a pool pump puts out, and do I need to completely shut the system down and dry the pipe before applying it? I know it says 'cures underwater' on the package, but I want to make sure I'm not just wasting my time with a fix that'll blow off the minute I fire the pump back up.

Is this a real repair I can count on, or am I just buying myself a little time before I have to do the full re-glue job anyway? Happy to do the proper fix eventually, but if this buys me a season I'm all for it.…more

My pool equipment pad has a waste line that just dumps straight out to the side yard with zero control — no valve, nothing. I found a YouTube tutorial on how to splice in a shutoff valve, grabbed the supplies, and cut into the pipe... and now I've got a bigger mess than before. The dry-fit didn't hold the way the video showed, one of my cuts came out slightly angled, and I'm second-guessing the whole thing before I actually glue anything permanently.

The waste line is 1½-inch PVC coming off the back of my multiport filter valve. It dribbles between backwash cycles because there's nothing shutting it off, and I'd like to fix that properly. I want to understand what type of valve to actually use here, how to prep the pipe ends correctly after a rough cut, and how to solvent-weld everything so it doesn't leak or blow apart under pressure.

Can someone walk me through the real process — choosing the right valve, making clean cuts, dry-fitting, priming and cementing, and how long I need to wait before firing the pump back up? I want to get this right the second time.…more

After two weeks of watching my pool devour water at 3/4 inch per day with zero swimmers, I'm convinced there's a serious leak somewhere. My pool is 20,000 gallons, rectangular, and about 8 years old. The water chemistry seems fine - chlorine at 2.5 ppm, pH at 7.4, alkalinity at 110 ppm.

I know pools naturally lose some water to evaporation, especially here in Arizona where it's been hitting 105°F daily. But this seems like a lot more than usual. I've checked around the equipment pad and don't see any obvious puddles or wet spots. The pool company that installed it said minor water loss is normal, but I'm starting to worry this might actually be a leak.

What's the normal amount of water loss I should expect from evaporation alone? At what point should I be concerned that this is actually a structural leak rather than just normal evaporation? I want to catch any potential problems before they get worse and more expensive to fix.…more

I turned to a second opinion after my pool contractor quoted $3,000 to replumb my entire return system when I suspect these leaking jets might just need a simple repair. I keep losing water and can't pinpoint where it's going. The jets seem like the obvious suspect since they're these openings in the wall, but I honestly have no clue how they're put together or what could go wrong with them.

Is it even possible for the actual jets to leak? And if so, where would the leak typically happen - like around the edges where they meet the pool wall, or somewhere else entirely?…more

Getting quotes for a pool heater installation and they range from $2,500 to $6,000 depending on the contractor. Trying to figure out if I can tackle this myself to save some money. Got decent plumbing skills and already ran the gas line for our grill last year — is a pool heater install realistic for a handy homeowner?…more